Silhouette Cameo: how to get a clean cut every time!

Is your Cameo giving you clean cuts one minute and tearing your paper the next? Well, if it’s any consolation, you’re not alone. There’s a good chance this frustrating problem could be caused by something as simple as a dirty blade. 

If you are not deeply in love with your Cameo because it doesn’t always give you clean cuts, have a look inside your blade housing and tell me what you see. If it looks like the one in the photo below, then it’s time to give it a cleaning.


This is my blade. I was working on a card for a customer last night and all of a sudden, my Cameo started misbehaving and tearing up my paper–my good paper! I took the blade out of the machine and this is what it looked like: lots of paper debris clogging the opening where the blade lives. Of course, it can’t make clean cuts–it can’t even get close enough to the surface of the paper with all that debris stuck in it.




The blade definitely needed to be cleaned before I could go any further with my project. So, I pulled my trusty needle off my bulletin board, inserted it gently into the blade housing, and ran it around the opening several times. Chunks of debris began to fall out. I kept poking at it until I had removed as much as possible.




The photo on the left shows some of the debris that came out of that tiny opening. Of course, this is an enlarged view, but believe me, it was enough to completely clog the blade housing.





This is what it looked like when I finished cleaning it. You can still see some little bits on the lower edge, but they were not visible to my naked eye.

I made several more clean cuts after that cleaning and then pulled the blade out to have another look. It was all clogged up, again!

So, the bottom line is that if you want clean cuts, you must have a clean blade.

Take care of  your Cameo and it will give you the most glorious, intricate and clean cuts of any die-cutting machine on the market!